Mon - Fri 08:00-18:00

BMW F30/F31 3 Series 320D 163 BHP EDC1750 2012-onwards

235 BHP

Stage 1 Power

440 Nm

Stage 1 Torque

BMW F30-F31

BMW F30 F31 3 Series 320D 163 BHP EDC1750 2012-onwards: Advanced Stage 1 Remap

The BMW F30 F31 3 Series 320D, from 2012, equipped with the Bosch EDC1750 ECU, is perfectly suited for our advanced Stage 1 remap.

This remap takes your car from 163 BHP to an impressive 235 BHP, and increases torque from 380Nm to a commanding 440Nm. Our remapping process is designed to deliver power smoothly, enhancing your vehicle’s transmission and overall driving pleasure.

After installing our HDI Tuning Remap, the improved performance of your BMW will be immediately noticeable. Our focus isn’t just on boosting power; we ensure it is enhanced intelligently and safely. Our remap is custom-crafted to align with the engine’s air mass flow and specific characteristics, for a balanced and efficient drive.

At HDI Tuning, our expertise in BMW EDC1750 tuning means we provide a remap that is superior in performance and reliability to standard options.

Programming the Bosch EDC1750 ECU is straightforward with our MyGenius tool. This tool allows for easy programming over the OBD port and offers multiple remap options to suit your driving style and performance needs.

Price:

Programming Methods – OBD2 or KTAG

Programming via OBD EDC17

  • Obtain a suitable programming tool; we recommend to use Dimsport MyGenius.
  • Connect to the OBD port of your car, make sure you have battery support to the vehicle battery.
  • ID the ECU and then take a read of the ECUs flash memory.
  • Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
  • Send payment through our webshop.
  • We will modify the software and send back to you. This normally takes less than 2 to 3 hours during working days.
  • Using the same tool you can then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process.
  • Let your engine warm up and then take the car for a spin, enjoy the extra power!

Bench Programming via KTAG EDC17

  • Order a suitable tool such as KTAG
  • Install the tool to a reliable laptop.
  • The ECU must be removed from the vehicle, and then the ECU needs to be opened, don’t attempt this unless you know what you are doing otherwise you can damage the ECU.
  • Connect boot pin to processor and CAN hi Lo / +12v / GND to pins on ECU
  • ID the ECU and then take a read of the ECUs memories for a backup (please save separately, and not as a combined file).
  • Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
  • Send payment through our webshop.
  • We will modify the software and send back to you. This normally takes less than 2 to 3 hours during work days.
  • Using the same tool, ID then write to the ECU. This will overwrite the ECUs memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about (You can always repair an ECU if you take a full backup of all memories).
  • Straighten the lid on the ECU and seal with a little silicone.
  • Refit the ECU and start the engine.
  • Let your engine warm up and then take the car for a spin, enjoy the extra power!