BMW E60 520D 174 BHP EDC17CP02 Stage 1 Remap
The BMW E60 520D which was produced between 2007 and 2009 is fitted with the Bosch EDC17CP02 ECU.
This engine variant responds very well to a Stage 1 remap and will get a big jump up in power as the factory setup leaves lots of available margin for tuning.
Our stage 1 remap transforms the standard 174 BHP to a commanding 230 BHP, while torque is enhanced from the base 350Nm to a strong 440Nm. We ensure the torque is delivered in a manner that’s both refined and smooth, safeguarding your clutch or automatic transmission and promising an exhilarating ride.
Driving your car with the HDI Tuning Remap installed will make it clear why our services are in high demand. Our approach to increasing power and torque prioritises not just performance but also the smoothness and reliability of your engine. The remap is intricately designed, with the torque curve fine-tuned to match the engine’s airflow dynamics and specific hardware.
At HDI Tuning, our proficiency extends beyond HDI vehicles. Our in-depth understanding of engine tuning, particularly for the BMW EDC17 sets us apart, surpassing the capabilities of the vast majority of tuning firms. Our remap for the BMW EDC17 is a testament to our advanced tuning expertise.
Programming the Bosch EDC17CP02 ECU is straightforward with our MyGenius tool, allowing for direct programming via the OBD port without the hassle of removing the ECU. This tool provides the flexibility to alter remaps at your leisure, and we can also offer multiple maps with difference power settings or delete options.
Price:
- Online remap MyGenius £120
- Online remap service £150
- Postal remap service £200
- Drive in remap from £250
Programming Methods – OBD2 or KTAG
Programming via OBD EDC17
- Obtain a suitable programming tool; we recommend to use Dimsport MyGenius.
- Connect to the OBD port of your car, make sure you have battery support to the vehicle battery.
- ID the ECU and then take a read of the ECUs flash memory.
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during working days.
- Using the same tool you can then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!
Bench Programming via KTAG EDC17
- Order a suitable tool such as KTAG
- Install the tool to a reliable laptop.
- The ECU must be removed from the vehicle, and then the ECU needs to be opened, don’t attempt this unless you know what you are doing otherwise you can damage the ECU.
- Connect boot pin to processor and CAN hi Lo / +12v / GND to pins on ECU
- ID the ECU and then take a read of the ECUs memories for a backup (please save separately, and not as a combined file).
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during work days.
- Using the same tool, ID then write to the ECU. This will overwrite the ECUs memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about (You can always repair an ECU if you take a full backup of all memories).
- Straighten the lid on the ECU and seal with a little silicone.
- Refit the ECU and start the engine.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!