Peugeot Boxer and Citroen Relay 3.0 HDI 16v 156 or 160 BHP EU4
When tuning your Peugeot boxer van or your Citroen Relay, you’re not only looking for a nice power gain with smooth and progressive torque delivery but you’re also looking for maximum reliability. That’s where we come in. Whether it’s your work van, a camper, or a minibus our Stage 1 performance software is designed to stay well within the limits of stock components whilst delivering the best possible performance without any compromise on reliability of the engine.
Our Stage 1 remap will deliver 204 BHP and a nice consistent torque curve which peaks at 490Nm. Although we could easily take more power from this engine, when tuning a van we like to keep things as safe and reliable as possible, because most of the time they are used as a work horse and you need to be able to count on them.
The HDI Tuning remap is guaranteed to outperform our competitors in terms of reliability and driveability, we’ve seen how they tune and we know that our remap for this engine type is much better, that’s because we’ve been working with Diesel tuning for over 12 years now!
- Program yourself with the MyGenius OBD tool, includes a Stage 1 Remap for just £290!
- Already have a programming tool? Use our Online remap service for just £150
- Send us your ECU – Use our Postal Remap Service £200
Programming Methods – OBD programming or Bench Programming
Programming via OBD EDC16C39
- Obtain a suitable programming tool; we recommend to use Dimsport MyGenius, you can also use Kess V2.
- Install the tool to a reliable laptop.
- Connect to the OBD port of your car, make sure you have backup chargers to the vehicle battery and the laptop battery.
- ID the ECU and then take a read of the ECUs flash memory.
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during working days.
- Using the same tool, ID then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!
Programming via KTAG EDC16C39
- Order a suitable tool such as Kess KTAG or BDM100.
- Install the tool to a reliable laptop.
- The ECU must be removed from the vehicle, and then the tabs on the lid can be carefully pried open and the casing of the ECU removed.
- Using a pogo spring probe connect to the ECU board, power the ECU to the ECU connector plugs as described by your programming tool.
- ID the ECU and then take a read of the ECUs memories for a backup (please save separately, and not as a combined file).
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during work days.
- Using the same tool, ID then write to the ECU. This will overwrite the ECUs memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about (You can always repair an ECU if you take a full BDM backup of all memories).
- Straighten the lid on the ECU and seal with a little silicone.
- Refit the ECU and start the engine.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!