Mon - Fri 08:00-18:00

1.5 dCi 110 2014-2020 Bosch EDC17C42 EU5 Renault Kangoo

130 BHP

Stage 1 Power

300 Nm

Stage 1 Torque

The Renault Kangoo 1.5 dCi with 110 BHP from the factory is a great candidate for ECU remapping.
A simple OBD programming procedure will deliver great results and make your van much more fun to drive.

Renault Kangoo 1.5 dCi 110BHP Stage 1 remap (130 BHP | 300 Nm)

The Stage 1 remap takes your 110 van up to 130 BHP peak power at the top end, and your mid range torque figure will increase to 300Nm. Most importantly this remap is safe and reliable, we never push things too far as reliability is key when tuning a work van.

Power delivery will be smooth and constant and you wont run out of power like the factory settings. The Stage 1 remap will really transform the way your van drives.
We’ve now got a ‘program at home’ option for the EDC17C42 ECU, supported by the MyGenius OBD Programmer unit. This device makes it super simple and safe to program the ECU yourself. The only additional equipment you’ll need is a battery charger/stabiliser.


Programming Methods – OBD2 or bench programming

Only genuine tuning tools can program the EDC17C42 over OBD such as Autotuner, Kess3 and now you can also program this ECU type from home using Dimsport MyGenius.

Recommended programming method:

Program over OBD using the Dimsport MyGenius standalone tool


The Dimsport MyGenius tool is the safest, easiest and most reliable way to program your ECU from home. Simply connect to the OBD port and let the tool do the work, no need to remove your ECU or bench program for most ECU types. For more information have a read here

Programming via Bench service mode PCM Flash or any tools with bench service mode

This is our preferred way to program. The ECU must be removed, but there is no need to open the ECU and risk damage. A full backup can be made of both the EEPROM and the internal flash memories, also the external flash can be read on models where this is present.

  • Order a tool such as PCM Flash.
  • Remove ECU from the vehicle.
  • Connect specified wires to ECU plug connector.
  • ID the ECU.
  • Read the ECU memories.
  • Email software to HDI Tuning.
  • Wait for us to prepare your remap and return it back to you.
  • Program the remap to the ECU using the same method taken to read the ECU.
  • Refit the ECU, check engine starts.
  • Let your engine warm up and then take the car for a spin, enjoy the extra power!

Programming via OBD EDC17C42

  • Obtain a suitable programming tool. We recommend Dimsport MyGenius if you want to program over OBD.
  • Install the tool to a reliable laptop.
  • Connect to the OBD port of your car, make sure you have backup chargers to the vehicle battery and the laptop battery.
  • ID the ECU and then take a read of the ECUs flash memory.
  • Email the software to along with a description of the remap you require.
  • Send payment through our webshop.
  • We will modify the software and send back to you. This normally takes less than 2 to 3 hours during working days.
  • Using the same tool, ID then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about.
  • Let your engine warm up and then take the car for a spin, enjoy the extra power!

If you’ve got a different 1.6 BlueHDI engine have a look here.