BMW F30 F31 3 Series 318D 147 BHP EDC1750 2015 onwards: Advanced Stage 1 Remap
The BMW F30 F31 3 Series 318D from 2015 onwards, fitted with the Bosch EDC1750 ECU, is perfectly suited for our advanced Stage 1 remap.
This remap boosts your car from the base 147 BHP to an astounding 235 BHP, and the torque from a standard 320Nm to an extraordinary 467Nm. Our remapping technique is engineered to provide a smooth yet significant increase in power, harmonizing perfectly with both manual and automatic transmissions, thus enhancing your driving pleasure.
Upon installing our HDI Tuning Remap, the difference in your vehicle’s performance will be evident. We don’t just amplify power and torque; we refine them with precision. Our remapping process is a meticulous exercise in engine tuning, focusing on optimizing the torque curve in line with air mass and engine specifics.
Our expertise at HDI Tuning goes beyond conventional tuning methods. We have an in-depth understanding of the BMW EDC17 series, ensuring that our remaps are a cut above the rest in terms of performance and reliability.
The Bosch EDC1750 ECU can be effortlessly programmed using our MyGenius tool. This tool facilitates programming directly over the OBD port and offers the convenience of switching between multiple remaps for different driving preferences and requirements.
Note: This model may use any of these Bosch ECU Versions EDC17C41 EDC17C50 EDC17C56
Price:
- Online remap MyGenius £120
- Online remap service £150
- Postal remap service £200
- Drive in remap from £250
Programming Methods – OBD2 or KTAG
Programming via OBD EDC17
- Obtain a suitable programming tool; we recommend to use Dimsport MyGenius.
- Connect to the OBD port of your car, make sure you have battery support to the vehicle battery.
- ID the ECU and then take a read of the ECUs flash memory.
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during working days.
- Using the same tool you can then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!
Bench Programming via KTAG EDC17
- Order a suitable tool such as KTAG
- Install the tool to a reliable laptop.
- The ECU must be removed from the vehicle, and then the ECU needs to be opened, don’t attempt this unless you know what you are doing otherwise you can damage the ECU.
- Connect boot pin to processor and CAN hi Lo / +12v / GND to pins on ECU
- ID the ECU and then take a read of the ECUs memories for a backup (please save separately, and not as a combined file).
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during work days.
- Using the same tool, ID then write to the ECU. This will overwrite the ECUs memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about (You can always repair an ECU if you take a full backup of all memories).
- Straighten the lid on the ECU and seal with a little silicone.
- Refit the ECU and start the engine.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!