BMW E90 E91 3 Series 318D 141 BHP EDC1741 Stage 1 Remap
The BMW E90 E91 3 Series 318D with the Bosch EDC1741 ECU is an excellent candidate for our advanced Stage 1 remap.
Elevating your car from 141 BHP to an impressive 199 BHP, this remap also increases torque from 300Nm to a substantial 390Nm. Our tuning method ensures a smooth yet significant increase in power. This translates to a more enjoyable drive and a marked improvement in acceleration while maintaining the health of your transmission.
Experiencing our HDI Tuning Remap will redefine your driving experience. We focus on safe and intelligent power upgrades. By carefully adjusting engine maps, we achieve a balance that enhances air mass utilization and respects the unique characteristics of your engine.
At HDI Tuning, our expertise goes beyond standard practices. Our deep understanding of engine dynamics, especially in BMW EDC1741 tuning, ensures our remaps stand out. You receive a finely-tuned performance enhancement that is both efficient and effective.
The Bosch EDC1741 ECU programming is hassle-free with our MyGenius tool. This tool allows easy remap changes via the OBD port and we can provide several map options for different performance needs.
Price:
- Online remap MyGenius £120
- Online remap service £150
- Postal remap service £200
- Drive in remap from £250
Programming Methods – OBD2 or KTAG
Programming via OBD EDC17
- Obtain a suitable programming tool; we recommend to use Dimsport MyGenius.
- Connect to the OBD port of your car, make sure you have battery support to the vehicle battery.
- ID the ECU and then take a read of the ECUs flash memory.
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during working days.
- Using the same tool you can then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!
Bench Programming via KTAG EDC17
- Order a suitable tool such as KTAG
- Install the tool to a reliable laptop.
- The ECU must be removed from the vehicle, and then the ECU needs to be opened, don’t attempt this unless you know what you are doing otherwise you can damage the ECU.
- Connect boot pin to processor and CAN hi Lo / +12v / GND to pins on ECU
- ID the ECU and then take a read of the ECUs memories for a backup (please save separately, and not as a combined file).
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during work days.
- Using the same tool, ID then write to the ECU. This will overwrite the ECUs memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about (You can always repair an ECU if you take a full backup of all memories).
- Straighten the lid on the ECU and seal with a little silicone.
- Refit the ECU and start the engine.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!