Mon - Fri 08:00-18:00
remap@hdi-tuning.co.uk   

3.0D V6 295 BHP Bosch EDC17CP55 Jaguar XF

330 BHP

Stage 1 Power

750 Nm

Stage 1 Torque

Banner

Stage 1 Performance Remap Jaguar XF 3.0D V6 EDC17CP55 (330 BHP | 750 Nm)

Unlock the full potential of your Jaguar XF 3.0D V6 with our Stage 1 Remap, masterfully enhancing performance from 295 BHP to an incredible 330 BHP, along with a robust torque boost to 750Nm. Our remap is designed to run within the safe limits of your auto gearbox and that’s why we cap torque at 750Nm

Our remap for the Bosch EDC17CP55 ECU perfects your vehicle’s performance, while meticulously maintaining the integrity of the DPF system and preventing any blockage issues. Expect not only a remarkable increase in power but also a smoother, more responsive driving experience.

Our remapping service strikes an ideal balance between enhanced performance and reliability. The remap provides a consistent 50Nm increase throughout the entire rev range, offering a significant upgrade that elevates every aspect of your driving experience.

Price:

Programming via OBD EDC17

  • Obtain a suitable programming tool; we recommend to use Dimsport MyGenius.
  • Connect to the OBD port of your car, make sure you have battery support to the vehicle battery.
  • ID the ECU and then take a read of the ECUs flash memory.
  • Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
  • Send payment through our webshop.
  • We will modify the software and send back to you. This normally takes less than 2 to 3 hours during working days.
  • Using the same tool you can then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process.
  • Let your engine warm up and then take the car for a spin, enjoy the extra power!

Bench Programming via KTAG EDC17

  • Order a suitable tool such as KTAG
  • Install the tool to a reliable laptop.
  • The ECU must be removed from the vehicle, and then the ECU needs to be opened, don’t attempt this unless you know what you are doing otherwise you can damage the ECU.
  • Connect boot pin to processor and CAN hi Lo / +12v / GND to pins on ECU
  • ID the ECU and then take a read of the ECUs memories for a backup (please save separately, and not as a combined file).
  • Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
  • Send payment through our webshop.
  • We will modify the software and send back to you. This normally takes less than 2 to 3 hours during work days.
  • Using the same tool, ID then write to the ECU. This will overwrite the ECUs memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about (You can always repair an ECU if you take a full backup of all memories).
  • Straighten the lid on the ECU and seal with a little silicone.
  • Refit the ECU and start the engine.
  • Let your engine warm up and then take the car for a spin, enjoy the extra power!