Mon - Fri 08:00-18:00
remap@hdi-tuning.co.uk   

3.0 TDV6 254 BHP Bosch EDC17CP55 Land Rover Discovery

305 BHP

Stage 1 Power

700 Nm

Stage 1 Torque

Banner

Stage 1 Performance Remap Land Rover Discovery 3.0 TDV6 EDC17CP55 (305 BHP | 700 Nm)

Elevate the performance of your Land Rover Discovery 3.0 TDV6 with our Stage 1 Remap, significantly boosting output from 254 BHP to a remarkable 305 BHP, and a monumental torque increase to 700Nm. Precision-designed for the 3.0 TDV6 engine, this remap has been thoroughly tested on automatic gearboxes to deliver the full 700Nm.

Featuring the advanced Bosch EDC17CP55 ECU, our remap finely optimises your Discovery’s performance while preserving the DPF system, preventing any clogging concerns. Expect a substantial rise in power, and a smoother, more responsive driving experience.

Our remapping service strikes an ideal balance between heightened performance and reliability. The remap delivers a consistent 100Nm increase throughout the entire rev range, providing an invigorating enhancement that uplifts every dimension of your drive.

Price:

Programming via OBD EDC17

  • Obtain a suitable programming tool; we recommend to use Dimsport MyGenius.
  • Connect to the OBD port of your car, make sure you have battery support to the vehicle battery.
  • ID the ECU and then take a read of the ECUs flash memory.
  • Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
  • Send payment through our webshop.
  • We will modify the software and send back to you. This normally takes less than 2 to 3 hours during working days.
  • Using the same tool you can then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process.
  • Let your engine warm up and then take the car for a spin, enjoy the extra power!

Bench Programming via KTAG EDC17

  • Order a suitable tool such as KTAG
  • Install the tool to a reliable laptop.
  • The ECU must be removed from the vehicle, and then the ECU needs to be opened, don’t attempt this unless you know what you are doing otherwise you can damage the ECU.
  • Connect boot pin to processor and CAN hi Lo / +12v / GND to pins on ECU
  • ID the ECU and then take a read of the ECUs memories for a backup (please save separately, and not as a combined file).
  • Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
  • Send payment through our webshop.
  • We will modify the software and send back to you. This normally takes less than 2 to 3 hours during work days.
  • Using the same tool, ID then write to the ECU. This will overwrite the ECUs memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about (You can always repair an ECU if you take a full backup of all memories).
  • Straighten the lid on the ECU and seal with a little silicone.
  • Refit the ECU and start the engine.
  • Let your engine warm up and then take the car for a spin, enjoy the extra power!