Sprinter 211-311-511 109 BHP Stage 1 Tuning
When tuning your Mercedes Sprinter, you’re not only looking for a nice power gain with smooth and progressive torque delivery but you’re also looking for maximum reliability. That’s where we come in. Whether it’s your work van, a camper, or a minibus our Stage 1 performance software is designed to stay well within the limits of stock components whilst delivering the best possible performance without any compromise on reliability of the engine.
Our Stage 1 remap for your 109 BHP engine is basically a factory upgrade to the 130 software with a tiny bit added on top. The stage 1 remap gives 135 BHP and a torque increase to 320Nm.
Sprinter 211-311-511 109 BHP Stage 2 Tuning
The stage 2 remap gives us a much bigger power gain whilst staying nice and safe due to using the factory 150 settings. The stage 2 remap will deliver 150 BHP and a torque increase to 350Nm. Although this seems like a big jump in power, it’s an easy gain as the 109 BHP engine is down-tuned from the factory.
You can program the ECU yourself using our online remapping service. For this we recommend to use the Kess V2 tool. With this tool you can you program directly over the OBD port.
If you prefer to send the ECU to us for the programming work, you can use our postal remap service.
Price:
- Online remap MyGenius £120
- Online remap service £150
- Postal remap service £200
- Drive in remap from £250
Programming Methods – OBD programming or Bench Programming
Programming via OBD EDC16C31
- Obtain a suitable programming tool; we recommend to use Dimsport MyGenius, you can also use Kess V2.
- Install the tool to a reliable laptop.
- Connect to the OBD port of your car, make sure you have backup chargers to the vehicle battery and the laptop battery.
- ID the ECU and then take a read of the ECUs flash memory.
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during working days.
- Using the same tool, ID then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!
Programming via KTAG EDC16C31
- Order a suitable tool such as Kess KTAG or BDM100.
- Install the tool to a reliable laptop.
- The ECU must be removed from the vehicle, and then the tabs on the lid can be carefully pried open and the casing of the ECU removed.
- Using a pogo spring probe connect to the ECU board, power the ECU to the ECU connector plugs as described by your programming tool.
- ID the ECU and then take a read of the ECUs memories for a backup (please save separately, and not as a combined file).
- Email the software to remap@hdi-tuning.co.uk along with a description of the remap you require.
- Send payment through our webshop.
- We will modify the software and send back to you. This normally takes less than 2 to 3 hours during work days.
- Using the same tool, ID then write to the ECU. This will overwrite the ECUs memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about (You can always repair an ECU if you take a full BDM backup of all memories).
- Straighten the lid on the ECU and seal with a little silicone.
- Refit the ECU and start the engine.
- Let your engine warm up and then take the car for a spin, enjoy the extra power!