Mon - Fri 08:00-18:00

2.0 TDCI EU5 160 BHP 2010–2015 Delphi DCM3.5 Ford Mondeo

190 BHP

Stage 1 Power

420 Nm

Stage 1 Torque

The Ford Mondeo is a striking vehicle, offering a solid 160 BHP straight off the production line. Its 2.0 TDCI engine holds untapped potential and with a stage 1 remap you can elevate its performance from enjoyable to exhilarating! A stage 1 remap is totally engine-friendly, eliminating the need for additional component upgrades. For those aiming higher, we also offer stage 2 and stage 3 enhancements which require small but simple modifications.

Stage 1 Remap Ford Mondeo 2.0 TDCI 160 (190 BHP | 420 Nm)

Our Stage 1 ECU remap boosts the Ford Mondeo 160 model to an impressive 190 BHP. This upgrade significantly heightens driving pleasure, facilitating safer overtaking. With our stage 1 remap you’ll experience a robust torque of 420 Nm, adding a considerable kick. This level of torque is clutch and transmission friendly, but do ensure your clutch is in good condition and not overly worn. We also offer lower power remaps, customising our software to meet your specific requirements.

You’ll notice a smoother, more consistent power delivery across the rev range post-remap, akin to driving a newer, more powerful factory model without the expense of buying a new car. The increased low-end torque also means you can often use higher gears, potentially improving fuel efficiency.

We provide DIY ECU programming options with the Dimsport MyGenius tool, available in our webshop. Alternatively, you can visit our various locations for professional programming services.


Stage 2 with performance exhaust (210 BHP | 440 Nm)

The Stage 2 remap is designed to run with an intercooler upgrade, and a free-flowing straight through style exhaust system. This remap delivers some extra top end power for those looking for that little bit extra. The exhaust work is important for this higher power remap, you likely won’t achieve the full power of this stage 2 remap without the additional exhaust work. It’s an option to increase the exhaust bore from the DPF onwards or to use a sports DPF and this will keep the vehicle road legal. With 440Nm of torque and 210+ BHP you’re going to notice a big performance gain when running this remap.

Programming Methods – OBD2

The Delphi DCM 3.5 ECU is fast and reliable to program directly over OBD, there is no need to remove the ECU.

Programming via OBD Delphi DCM3.5

  • Obtain a suitable programming tool; we recommend to use Dimsport MyGenius, you can also use Kess V2.
  • Install the tool to a reliable laptop.
  • Connect to the OBD port of your car, make sure you have backup chargers to the vehicle battery and the laptop battery.
  • ID the ECU and then take a read of the ECUs flash memory.
  • Email the software to along with a description of the remap you require.
  • Send payment through our webshop.
  • We will modify the software and send back to you. This normally takes less than 2 to 3 hours during work days.
  • Using the same tool, ID then write to the ECU. This will overwrite the ECUs flash memory, it’s important not to interrupt the process. If you encounter any problems we can fix the ECU for you so there’s absolutely nothing to worry about.
  • Let your engine warm up and then take the car for a spin, enjoy the extra power!