1.5 BlueHDI 120 BHP DV5TED4 Bosch MD1CS003 EU6.2 Toyota ProAce 2

The Toyota ProAce 2 1.5 BlueHDI 120 Engine comes fitted with a very advanced Bosch MD1 tuning protected ECU. There are many levels of tuning protection in this ECU but our advanced programming equipment and bespoke tuning software can overcome all of this safely, best of all we can program this ECU without needing to open or dismantle the ECU. The Bosch MD1CS003 must be bench programmed using bench service mode over the CAN line, currently there are no tools that can do this over OBD.

Toyota ProAce 2 1.5 BlueHDI 120 Stage 1 Remap (150 BHP | 330 Nm)

We’ve been working hard to bring to you the latest and most advanced remap available for the Toyota ProAce 2 1.5 DV5TED4 BlueHDI Engine. Our Stage 1 remap will safely take your peak power to 150 BHP and peak torque is an exciting 330Nm with a smooth and consistent torque curve.

The Toyota ProAce 2 1.5 HDI 120 engine comes fitted with a fourth generation Garrett GTD1244 turbo charger which delivers great spool up characteristics, brilliant top end power and is a very strong and reliable turbo. We keep turbo pressure well within the safe range for this turbo so you don’t need to worry about reduced reliability when remapping your engine (we like the GTD12 turbo so much that we actually retro fit it to older variants of the 1.6 HDI engine).

Price:

• Online remap MyGenius £120
• Online remap service £150
• Postal remap service £200
• Drive in remap from £250

Programming Methods – bench programming

The Bosch MD1 ECU can be programmed using Bitbox and a Scanmatik 2 device.

Programming via Bench service mode over CAN with Bitbox

This is our preferred way to program. The ECU must be removed, but there is no need to open the ECU and risk damage. A full backup can be made of both the EEPROM and the internal flash memories.

• Order a Scanmatik 2 Pro J2534 programming device and a Bitbox dongle with the MD1 license.
• Remove ECU from the vehicle.
• Connect specified wires to ECU plug connector.
• ID the ECU.
• Read the ECU memories.
• Email software to HDI Tuning.
• Wait for us to prepare your remap and return it back to you.
• Program the remap to the ECU using the same method taken to read the ECU.
• Refit the ECU, check engine starts.
• Let your engine warm up and then take the car for a spin, enjoy the extra power!